Create Bootable USB Drive

Open the Command Prompt. You will need to run Command Prompt as an Administrator. Right-click on it and select Run as Administrator.
Open the disk management utility. This can be opened by entering the command disk part
Microsoft DiskPart version 10.0.15063.0
Copyright (C) Microsoft Corporation.
On computer:
Display the connected disks. Type the command list disk to show a list of all the drives connected to your computer. Your USB drive should be listed here as well. Make note of the number next to your USB drive.
DISKPART> list disk
Disk ### Status Size Free Dyn Gpt
——– ————- ——- ——- — —
Disk 0 Online 465 GB 1024 KB *
Disk 1 Online 29 GB 29 GB

image
DISKPART> select disk 1
Disk 1 is now the selected disk.
Clean the flash drive. Enter the command clean to have the disk management utility verify the integrity of the USB drive, and erase all data.

DISKPART> clean
DiskPart succeeded in cleaning the disk.

image
DISKPART> create partition primary
DiskPart succeeded in creating the specified partition.

DISKPART> active
DiskPart marked the current partition as active.

image
Format the USB drive. Input the command format fs=fat32. When you press Enter, the program will work for a few minutes (if it is a small USB, e.g. 32Gb could actually take hours to SLOW format

image

DISKPART> format fs=fat32
100 percent completed
DiskPart successfully formatted the volume.

image

DISKPART> assign
DiskPart successfully assigned the drive letter or mount point.

DISKPART> exit

VPS Hosting

Assign the USB a drive letter. Enter the command assign to give the thumb drive a letter designation. Type exit to end the disk management program.

You can then copy the contents of an operating installation disc onto the drive to create a portable installation drive.

Click to rate this post!
[Total: 0 Average: 0]

Share and Enjoy !

Shares
Get Weekly KBV Tips !

Learn and improve day to day Knowledge & lifestyles.